SCR 2500 is series single pipe station for cutting & calibration of composite pipe ends. It is used for pipe edge cutting with saw and machining of symmetrical cross-transverse groves with milling operation. These operations are necceesary for preparing the pipes for connection when making gas and oil transportation pipelines, water transportation and sewage treatment.

General technical data:

Spindle axis – axis 1

Maximum pipe diameter: 2500mm
Minimum pipe diameter: 300mm
Maximum pipe length: 12 500mm
Maximum pipe weight capacity: 4000 kg

AC motor driven pipe rotation, with speed regulation;

Maximum rotation speed of the pipe rotation: 5 RPM

Tooling – 3 – jaw chucks for inside holding of the pipes during cutting operation

Carriage axis – axis 2

Horizontal carriage stroke: 13 500 mm
Drive system - Manual drive

Cross – traveling axis with working tool – axis 3:

Cross – traveling axis stroke: 1150 mm
Drive system - Manual drive 

Cutting tool unit

AC driving cutting tool: motor spindle 9.2KW
Maximum cutting tools rotation speed: 0 - 2800 RPM
Drive system: trapezoidal screw manual drive
Width of the shaft for cutting tools installation: 400mm

Pneumatic or hydraulic supported Elevator System for holding the pipes during loading/unloading phases
Motor driven elevator system for pipe release phase
Dust Suction Device and duct line

Features:

E – Stop reset function
Start and stop function
Feed rate control
Manual mode of operation

Power requirements:

Electricity: 380 V, 3 phase, 50 Hz
Compressed Air: 6 – 8 bar